اخبار و اعلانات

 آمار

تعداد نشریات24
تعداد شماره‌ها935
تعداد مقالات8,386
تعداد مشاهده مقاله16,984,601
تعداد دریافت فایل اصل مقاله14,373,583
HUSSAIN, A., ABOLABAN, F., KHUBAIB, S. M., MUBIN, S., AHMED, I.. (1394). STEADY STATE AND TRANSIENT THERMALHYDRAULIC ANALYSIS OF PHWR USING COBRA-3C/RERTR. , 39(M1+), 233-242. doi: 10.22099/ijstm.2015.3002
A. HUSSAIN; F. ABOLABAN; S. M. KHUBAIB; S. MUBIN; I. AHMED. "STEADY STATE AND TRANSIENT THERMALHYDRAULIC ANALYSIS OF PHWR USING COBRA-3C/RERTR". , 39, M1+, 1394, 233-242. doi: 10.22099/ijstm.2015.3002
HUSSAIN, A., ABOLABAN, F., KHUBAIB, S. M., MUBIN, S., AHMED, I.. (1394). 'STEADY STATE AND TRANSIENT THERMALHYDRAULIC ANALYSIS OF PHWR USING COBRA-3C/RERTR', , 39(M1+), pp. 233-242. doi: 10.22099/ijstm.2015.3002
HUSSAIN, A., ABOLABAN, F., KHUBAIB, S. M., MUBIN, S., AHMED, I.. STEADY STATE AND TRANSIENT THERMALHYDRAULIC ANALYSIS OF PHWR USING COBRA-3C/RERTR. , 1394; 39(M1+): 233-242. doi: 10.22099/ijstm.2015.3002

STEADY STATE AND TRANSIENT THERMALHYDRAULIC ANALYSIS OF PHWR USING COBRA-3C/RERTR

Iranian Journal of Science and Technology Transactions of Mechanical Engineering
مقاله 8، دوره 39، M1+، مرداد 2015، صفحه 233-242    اصل مقاله (530.97 K)
نوع مقاله: Research Paper
شناسه دیجیتال (DOI): 10.22099/ijstm.2015.3002
نویسندگان
A. HUSSAIN* 1؛ F. ABOLABAN1؛ S. M. KHUBAIB2؛ S. MUBIN3؛ I. AHMED4
1Dept. of Nuclear Engineering, King Abdulaziz University, Jeddah, KSA
2Dept. of Mechanical Engineering, Nazeer Hussain University, Karachi, Pakistan
3Dept. of Civil Engineering, University of Engineering & Technology, Lahore, Pakistan
44Dept. of Chemical Engineering, University Technology PETRONAS, Perak, Malaysia
چکیده
Nuclear cross sections that determine core multiplication strongly depend on core temperature (e.g., the Doppler, moderator density effects etc). On the other hand, since this heat is generated by the neutron flux in the reactor core, the temperature distribution in the core will depend heavily on its neutronic behavior. Fuel centerline temperature could be the limiting constraint on reactor power because of the concern for fuel melting. Likewise, high clad temperature is also a possible limiting factor on reactor power because of the potential degradation of clad material or on-set of critical heat flux phenomenon.
An assessment of the steady state and transient thermal hydraulic capabilities of the computer code COBRA 3C/RERTR was made using model for a PHWRs reactor core. The temperature distributions determined for fuel, clad and coolant are compared with analytical results and with the results quoted in safety report. It was found that when the code was run for full power at reduced flow of 70% the bulk coolant temperature remained below the saturation temperature, so there is an adequate design margin is available for safety related scenarios.
کلیدواژه‌ها
Thermal hydraulic analysis؛ PHWRs؛ fuel temperatures؛ COBRA/RERTR code؛ reactor safety
آمار
تعداد مشاهده مقاله: 3,712
تعداد دریافت فایل اصل مقاله: 2,997


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب